nRF24L01+PA+LNA Antenna Wireless Transceiver RF Transceiver Module for Arduino
Price : 370 Taka
Product description
Product description
The Addicore nRF24L01 is a 2.4GHz ISM band transceiver. The transceiver consists of a fully integrated frequency synthesizer, a power amplifier, a crystal oscillator, a demodulator, modulator and enhanced ShockBurst, protocol engine.
A host microcontroller can communicate and configure the nRF24L01+ over a 4-pin Serial Peripheral Interface (SPI). The configuration registers are accessible through the SPI connection.
Configurable parameters include frequency channel (125 selectable channels), output power, and data rate (data rates: 250kbps, 1Mbps, and 2Mbps).
The module has 5V tolerant inputs which allows direct connection of SPI pins to the Arduino.
* Model:NRF24L01;
* nRF24L01 is a single chip radio transceiver for
the world wide 2.4 - 2.5 GHz ISM band.
* The transceiver consists of a fully integrated
frequency synthesizer, a power amplifier, a
crystal oscillator, a demodulator, modulator and
Enhanced ShockBurst? protocol engine.
* Output power, frequency channels, and
protocol setup are easily.
* programmable through a SPI interface. Current
consumption is very low, only 9.0mA at an output
power of -6dBm and 12.3mA in RX mode.
* Built-in Power Down and Standby modes
makes power saving easily realizable.
* Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability,
Particularly suitable for industrial control
applications.
* 125 Communications channels, Multi-point
communication and frequency hopping to meet
the communication needs.
* Built-in hardware CRC error detection,
Multipoint communication address control.
* Low-power 1.9 ~ 3.6V, only 1uA on Power down mode.
* Built-in 2.4Ghz antenna.
A host microcontroller can communicate and configure the nRF24L01+ over a 4-pin Serial Peripheral Interface (SPI). The configuration registers are accessible through the SPI connection.
Configurable parameters include frequency channel (125 selectable channels), output power, and data rate (data rates: 250kbps, 1Mbps, and 2Mbps).
The module has 5V tolerant inputs which allows direct connection of SPI pins to the Arduino.
* Model:NRF24L01;
* nRF24L01 is a single chip radio transceiver for
the world wide 2.4 - 2.5 GHz ISM band.
* The transceiver consists of a fully integrated
frequency synthesizer, a power amplifier, a
crystal oscillator, a demodulator, modulator and
Enhanced ShockBurst? protocol engine.
* Output power, frequency channels, and
protocol setup are easily.
* programmable through a SPI interface. Current
consumption is very low, only 9.0mA at an output
power of -6dBm and 12.3mA in RX mode.
* Built-in Power Down and Standby modes
makes power saving easily realizable.
* Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability,
Particularly suitable for industrial control
applications.
* 125 Communications channels, Multi-point
communication and frequency hopping to meet
the communication needs.
* Built-in hardware CRC error detection,
Multipoint communication address control.
* Low-power 1.9 ~ 3.6V, only 1uA on Power down mode.
* Built-in 2.4Ghz antenna.
No comments