NRF24L01+ 2.4GHz Wireless RF Transceiver Module New

Price :190Taka

Product description

The Addicore nRF24L01 is a 2.4GHz ISM band transceiver. The transceiver consists of a fully integrated frequency synthesizer, a power amplifier, a crystal oscillator, a demodulator, modulator and enhanced ShockBurst, protocol engine. 
A host microcontroller can communicate and configure the nRF24L01+ over a 4-pin Serial Peripheral Interface (SPI). The configuration registers are accessible through the SPI connection. 
Configurable parameters include frequency channel (125 selectable channels), output power, and data rate (data rates: 250kbps, 1Mbps, and 2Mbps). 
The module has 5V tolerant inputs which allows direct connection of SPI pins to the Arduino. 

* Model:NRF24L01; 
* nRF24L01 is a single chip radio transceiver for 
the world wide 2.4 - 2.5 GHz ISM band. 
* The transceiver consists of a fully integrated 
frequency synthesizer, a power amplifier, a 
crystal oscillator, a demodulator, modulator and 
Enhanced ShockBurst? protocol engine. 
* Output power, frequency channels, and 
protocol setup are easily. 
* programmable through a SPI interface. Current 
consumption is very low, only 9.0mA at an output 
power of -6dBm and 12.3mA in RX mode. 
* Built-in Power Down and Standby modes 
makes power saving easily realizable. 
* Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability, 
Particularly suitable for industrial control 
applications. 
* 125 Communications channels, Multi-point 
communication and frequency hopping to meet 
the communication needs. 
* Built-in hardware CRC error detection, 
Multipoint communication address control. 
* Low-power 1.9 ~ 3.6V, only 1uA on Power down mode. 
* Built-in 2.4Ghz antenna.